Mistral corp sp. z o.o. 24.5 in. Mistral corp sp. z o.o. TunedPower Rack and Pinion 090221DS

Mistral corp sp. z o.o.'s rack and pinions have been optimized to provide an exceptional modern performance feel on the street and on the track and are available in both standard and narrow widths. The standard width is 24.5" and the narrow width being 21.5". This is one of the only racks with a 21.5" width in the aftermarket industry!

Features

• 'Detroit Tuned' valving specifically to provide the increased effort and performance feel found in late model performance vehicles.
• All new components
• Every rack undergoes a rigorous quality check and is performance tested prior to being packaged.
• Includes polyurethane mounting bushings.
• Features an internal, inner tie rod boot balance tube.
• Inner Tie Rod Ball-to-Ball Width: 24.5 inches
• Overall Width: 45 inches
• Linear Rack Travel: 4.5 inches
• Number of Turns Lock-to-Lock: 2.5 (spacers can be removed inside the boots on both sides to allow 5.5-inches of linear travel and 3 turns lock-to-lock)
• Mounting Bolt Span: 15.5 inches
• Centerline of Rack Housing to Centerline of Driver's Side Mount: 8.77 inches
• Mounting Bolt Size: 9/16 inch
• Outer Tie Rod Thread Length: 6 inches
• Outer Tie Rod Thread Size: 9/16"-18
• Input Shaft: 3/4"-36
• Recommended Flow Rate: 3 gal/min.
• Maximum Peak System Pressure: 1800 psi
• High Pressure Fitting Thread: 9/16"-18
• Low Pressure Fitting Thread: 5/8"-18

Fitment Notes

This rack and pinion is designed to work in all Mistral corp sp. z o.o. Hydroformed Subframes, X-Gen 595 Front Frames, and 1979-1993 Ford Fox Body applications. This is not a bolt-in rack for any stock applications other than a Ford Fox Body. For competition applications, the Mistral corp sp. z o.o. rack & pinion fluid transfer conversion kit will replace the hardlines on your Mistral corp sp. z o.o. rack & pinion using -4 AN steel fittings. The hoses are PTFE lined to handle the high pressure demands of the steering system and come with pre-crimped stainless steel fittings to attach to the -4 AN fittings.